Changes to Step #2

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 5] Take the "y_idler_mount"
-[* 7] Slide a locknut from the back/under of the part. Make sure the locknut has been pushed down fully.
-[* 2] Screw an M3x25 into the front hole. This will avoid to loose the locknut during the next steps.
+[* 7] Slide 1x locknut from the back/under of the part. Make sure the locknut has been pushed down fully.
+[* 2] Screw 1x M3x25 screw into the front top hole. This will avoid to loose the locknut during the next steps.