Changes to Step #2
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Prepare Y idler mount |
|---|---|
| [* 5] Take the "y_idler_mount" | |
| [* 7] Slide 1x locknut from the back/under of the part. Make sure the locknut has been pushed down fully. | |
| [* 2] Screw 1x M3x25 screw into the front top hole. This will avoid to loose the locknut during the next steps. |