Changes to Step #3

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[* 5] Slide one t-nuts in the lower of the front extrusion
-[* 7] Using M5x10, assemble the ''y_idler_mount''. Make sure to tighten the screw ***incrementally***. The exact position will be set later.
+[* 5] Slide 1x t-nut in the lower of the front extrusion
+[* 7] Using 3x M5x10, assemble the ''y_idler_mount''. Make sure to tighten the screw ***incrementally***. The exact position will be set later.