Changes to Step #3
Edit by Dave Ogles —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Install Y idler mount | |
| - | [* 5] Slide 1x t-nut in the lower of the front extrusion, as shown. |
| + | [* 5] Slide 1x t-nut in the lower channel of the front extrusion, as shown. |
| [* 7] Using 3x M5x10 screws, assemble the ''y_idler_mount''. Tighten them just enough to prevent the part from sliding. We will set the correct position later. | |
| [* 9] Do not fully tighten the part to the frame. We will adjust its final position when we align the belt path with the bed and motor. |