Changes to Step #10

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Prepare Y motor
-[* 1] pulley not touching (around 1mm) and grub screws are snug
[* 5] Take the Y axis motor.
-[* 3] Make sure the pulley is not touching the motor (around 1mm of spacing).
-[* 7] Make sure the grub screws are both tight.
-[* 1] Reserve the Y motor for later use.
+[* 3] Slide the 16T drive pulley on to the motor shaft, as shown. Make sure the pulley is not touching the motor (around 1mm of space between the motor body and drive pulley is enough).
+[* 7] Make sure the grub screws are both tight, ensuring that one of the grub screws is tightened against the flat part of the shaft.
+[* 1] Keep the Y motor for later use.