Changes to Step #12
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Y motor installation |
|---|---|
| [* 3] Place the Y motor on the ''y_motor_mount'' as shown on the first image. The cables must be orientated downward. | |
| [* 1] Secure the motor with the following screws. Do not tighten it strongly yet. | |
| [* 5] 2x M3x18 | |
| [* 7] 1x M3x10 | |
| [* 2] Finish to tighten the M3 screws while applying gentle pressure in the direction shown. | |
| [* 9] Verify the orientation of the motor cables. |