Changes to Step #12

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y motor installation - MK2(S)/MK2.5(S)
-[* 3] Place the Y motor on the ''y_motor_mount'' as shown on the first image. The cables must be orientated downward.
-[* 1] Secure the motor with the following screws. Do not tighten it strongly yet.
+[* 3] Place the Y motor on the ''y_motor_mount'' as shown in the first image. The cables must be orientated downward.
+[* 1] Secure the motor with the following screws. Do not fully tighten them yet.
[* 5] 2x M3x18
[* 7] 1x M3x10
-[* 2] Finish to tighten the M3 screws while applying gentle pressure in the direction shown.
-[* 9] Verify the orientation of the motor cables.
+[* 2] Whilst pushing in the direction shown, fully tighten all 3 screws.
+[* 9] Check that the motor cables are oriented corectly.