Changes to Step #12
Edit by Dave Ogles —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Y motor installation - MK2(S)/MK2.5(S) | |
| [* 3] Place the Y motor on the ''y_motor_mount'' as shown in the first image. The cables must be orientated downward. | |
| [* 1] Secure the motor with the following screws. Do not fully tighten them yet. | |
| [* 5] 2x M3x18 | |
| [* 7] 1x M3x10 | |
| [* 2] Whilst pushing in the direction shown, fully tighten all 3 screws. | |
| - | [* 9] Check that the motor cables are oriented |
| + | [* 9] Check that the motor cables are oriented correctly. |