Changes to Step #13
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] Y motor installation |
|---|---|
| + | [title] Y motor installation MK2(S)/MK2.5(S) |
| [* 6] Place the ''y_motor_endstop_mount'' and secure it with 1x M3x18 screw. | |
| [* 5] Place the Y end stop switch on the y_motor_endstop_mount with the clicking part aligned with the mark. | |
| [* 9] Make sure the orientation of the switch is correct! | |
| [* 8] Tighten 2x M2x12 screws to secure the end stop. ***Do not tighten too much as you might damage the end stop.*** | |
| [* 10] If it is too hard to screw the end stop you can use a 1.5mm drill bit. Be careful to not break the drill bit. |