Changes to Step #13

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y motor installation - MK2(S)/MK2.5(S)
-[* 6] Place the ''y_motor_endstop_mount'' and secure it with 1x M3x18 screw.
-[* 5] Place the Y end stop switch on the y_motor_endstop_mount with the clicking part aligned with the mark.
+[* 6] Place the ''y_motor_endstop_mount'', as shown, and secure it with 1x M3x18 screw.
+[* 5] Place the Y end stop on the y_motor_endstop_mount with the switch actuator aligned with the notch, as shown.
[* 9] Make sure the orientation of the switch is correct!
-[* 8] Tighten 2x M2x12 screws to secure the end stop. ***Do not tighten too much as you might damage the end stop.***
- [* 10] If it is too hard to screw the end stop you can use a 1.5mm drill bit. Be careful to not break the drill bit.
+[* 8] Insert and tighten 2x M2x12 screws to secure the end stop. ***Do not over tighten these screws, otherwise you may damage the end stop.***
+ [* 10] If it is too hard to tighten the M2 screws into the end stop mount, you may use a 1.5mm drill bit to clear the holes. Be careful that you do not break the drill bit.