Changes to Step #28

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y motor installation - MK3(S)
[* 2] Place the Y motor on the ''y_motor_mount'' as shown on the first image. The cables must be orientated downward.
-[* 5] Secure the motor with 3x M3x18 screws. Do not tighten it strongly yet.
-[* 7] Finish to tighten the M3x18 screws while applying gentle pressure in the direction shown.
-[* 9] Verify the orientation of the motor cables.
+[* 5] Secure the motor with 3x M3x18 screws. Do not fully tighten them yet.
+[* 7] Whilst pushing in the direction shown, fully tighten all 3 screws.
+[* 9] Check that the motor cables are oriented correctly.