Changes to Step #29
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Y motor installation |
|---|---|
| [* 1] Install the ''y_motor_mount'' on the extrusions in the back. Tighten the screws ***incrementally***. | |
| [* 3] 1x M5x12 on top. | |
| [* 5] 1x M5x16 on bottom. | |
| [* 9] Always tighten the y_motor_mount ***incrementally***. This ensure the motor is getting squared correctly. |