Changes to Step #29

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y motor installation - MK3(S)
-[* 1] Install the ''y_motor_mount'' on the extrusions in the back. Do not fully tighten the screws. We will set the position in Step 19.
+[* 1] Install the ''y_motor_mount'' on the extrusions in the back. Do not fully tighten the screws. We will set the position in a later step.
[* 3] 1x M5x12 on top.
[* 5] 1x M5x16 on bottom.
[* 9] Always tighten the ''y_motor_mount'' screws ***evenly, incrementally and in turn***. This ensures that the motor mount is properly square on the extrusions.