Changes to Step #14
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [* 1] Install the ''y_motor_mount'' on the extrusions in the back. Tighten the screws ***incrementally***. | |
| [* 3] 1x M5x12 on top | |
| [* 5] 1x M5x16 on bottom | |
| - | [* 9] Always tighten the y_motor_mount ***incrementally***. This ensure the motor is getting squared correctly. |
| + | [* 9] Always tighten the ''y_motor_mount'' ***incrementally***. This ensure the motor is getting squared correctly. |