Changes to Step #14

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y motor installation - MK2(S)/MK2.5(S)
-[* 1] Install the ''y_motor_mount'' on the extrusions in the back. Tighten the screws ***incrementally***.
+[* 1] Install the ''y_motor_mount'' on the extrusions in the back. Do not fully tighten the screws. We will set the position in Step 19.
[* 3] 1x M5x12 on top
[* 5] 1x M5x16 on bottom
-[* 9] Always tighten the ''y_motor_mount'' ***incrementally***. This ensure the motor is getting squared correctly.
+[* 9] Always tighten the ''y_motor_mount'' screws ***evenly, incrementally and in turn***. This ensures that the motor mount is properly square on the extrusions.