Changes to Step #6

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Prepare Y bearings
[* 10] We are now going to prepare a few parts that will be used later in this chapter. Let's start with the Y bearing holders.
-[* 3] Take the 3x ''y_bearing_holder'' and insert 2x locknuts in each of them (6x locknuts in total).
+[* 3] Take the 3x ''y_bearing_holder'' and insert 2x locknuts in each of them (6x locknuts in total). Those locknuts need to be reused from your Original Prusa printer.
[* 5] We need to make sure that the locknuts are fully inserted in their pocket. To do this, take 1x M3x18 screw and 1x washer.
[* 7] For each locknut in the ''y_belt_holders'', insert the screw and tighten it against the washer, until the locknut is fully seated.
[* 7] Remove the screw and washer and repeat for the 5 other locknuts of the bearing holders.
[* 9] Make sure the 6x locknuts are fully seated in the bearing holders.