Changes to Step #5

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Prepare for Y motor mount
[* 5] Remove the Y smooth rod you installed in the previous step.
-[* 2] Slide 1x t-nut on the lower side of the back extrusion.
- [* 10] Be careful to not loose this t-nut during the next steps.
+[* 2] Slide 1x t-nut into the lower channel of the rear extrusion, as shown.
+ [* 10] Be careful that this this t-nut does not fall out during the following steps. (Remember the tape / BluTack tip)