Changes to Step #4

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[* 9] Take your time with this step. This step could affect the alignment of the heatbed later.
-[* 3] Clip a Y smooth rod (330m long).
+[* 9] Take your time with this step, it could affect the alignment of the heatbed later.
+[* 3] Clip 1x Y smooth rod (330m long).
[* 5] Release the 4x M5x12 screws to have the ''y_rod_holders'' moving freely.
[* 7] With the help of the y_build_helper, adjust the position of the front ''y_rod_holder''. Tighten strongly once alignment is correct.
+ [* 9] Make sure the tool is correctly in contact with the smooth rods and the extrusion.
[* 2] Repeat to the back of the Y axis
[* 9] Verify again front and back alignment of the smooth rods. You might need to repeat adjustment to make it perfect.