Changes to Step #4

Edit by Schrödingers Cat —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Left smooth rod alignment
[* 9] Take your time with this step, it could affect the alignment of the heatbed later.
-[* 3] Clip 1x Y smooth rod (330m long) into the y-rod holders, on the left hand side.
+[* 3] Clip 1x Y smooth rod (330mm long) into the y-rod holders, on the left-hand side.
[* 5] Loosen the 4x M5x12 screws so that the ''y_rod_holders'' move easily.
[* 7] Using the ''y_build_helper'', adjust the position of the front ''y_rod_holder''. Once the alignment is correct, fully tighten the M5x12 screws.
[* 9] Make sure the ''y_build_helper'' is correctly seated against the extrusion and is in contact with the smooth rod.
[* 2] Using the same ''y_build_helper'', adjust and tighten the rear y-rod holder.
[* 9] Carefully check the alignment of the front and rear of the smooth rods. You may need to repeat the adjustment to get them perfectly aligned.