Changes to Step #15

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 5] Locate the marker of the Y carriage.
-[* 7] flip the carriage to have the marker facing the table (not visible from the top).
-[* 2] Bearing holders have two dots printed on one of the face. Place the bearing holder with the dots oriented as shown on the image.
+[* 7] Flip the carriage to have the marker facing the table (not visible anymore on the 2nd and 3rd image).
+[* 2] The ''y_bearing_holders'' have 2 dots printed on one of their corners. Place the 3x ''y_bearing_holders'' with the dots oriented as shown on the 2nd image.
[* 6] Secure the bearing holders with 6x M3x25 screws. Do ***NOT*** tighten yet!