Changes to Step #15

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y bearings installation - MK2(S)/MK2.5(S)
[* 5] Locate the marker of the Y carriage.
-[* 7] Flip the carriage to have the marker facing the table (not visible anymore on the 2nd and 3rd image).
+[* 7] Flip the carriage to have the marker facing the table (not visible anymore in the 2nd and 3rd image).
[* 2] The ''y_bearing_holders'' have 2 dots printed on one of their corners. Place the 3x ''y_bearing_holders'' with the dots oriented as shown on the 2nd image.
-[* 6] Secure the bearing holders with 6x M3x25 screws. Do ***NOT*** tighten yet!
+[* 6] Secure the bearing holders with 6x M3x25 screws. Do ***NOT*** tighten them yet!