Changes to Step #15
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Y bearings installation - MK2(S)/MK2.5(S) | |
| [* 5] Locate the marker of the Y carriage. | |
| [* 7] Flip the carriage to have the marker facing the table (not visible anymore in the 2nd and 3rd image). | |
| - | [* 2] The ''y_bearing_holders'' have 2 dots printed on one of their corners. Place the 3x ''y_bearing_holders'' with the dots oriented as shown on the 2nd image. |
| + | [* 2] The ''y_bearing_holders'' have ***2 dots*** printed on one of their corners. Place the 3x ''y_bearing_holders'' with the dots oriented as shown on the 2nd image. |
| + | [* 9] Double check the orientation of the ''y_bearing_holders'', this is important as you might have issues later with the heated bed. |
| [* 6] Secure the bearing holders with 6x M3x25 screws. Do ***NOT*** tighten them yet! |