Changes to Step #20
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Y belt holder installation |
|---|---|
| [* 7] Install the ''y_belt_holder'' under the Y carriage. The grooves should face the single bearing side. | |
| [* 5] 2x M3x12 (reused from your original Prusa). | |
| [* 8] 2x M3 hex nut (reused from your original Prusa). | |
| [* 9] Verify the orientation of the ''y_belt_holder''. |