Changes to Step #20

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y belt holder installation - MK2(S)/MK2.5(S)
[* 7] Install the ''y_belt_holder'' under the Y carriage. The grooves should face the single bearing side.
[* 5] 2x M3x12 (reused from your original Prusa).
- [* 8] 2x M3 hex nut (reused from your original Prusa). Note that those nuts will be removed when installing the heated bed, they are only temporary.
+ [* 8] 2x M3 hex nut. Note that those nuts will be removed when installing the heated bed, they are only temporary.
[* 9] Verify the orientation of the ''y_belt_holder''.