05. Y axis motion Step #30 History

Changes to Step #30

Edit by Grégoire Saunier — May 25, 2021

	[title] Y bearings installation - MK3(S)
	[* 9] Take your time with this step. It is important that it is done correctly or it can cause issues later with your printer. *Do not over-tighten the bearings* or you may cause permanent damage to them.
	[* 3] Secure the bearing holders with 6x M3x25 screws. Do *NOT* tighten them yet!
-	[* 5] Start tightening, *evenly, incrementally and in turn. the M3x25 screws. While tightening, test if the bearing can rotate in the directions shown by the red arrows. When it no longer moves, in this direction, stop tightening* immediately.
+	[* 5] Start tightening, *evenly, incrementally and in turn. the M3x25 screws. While tightening, test if the bearing holder can rotate in the directions shown by the red arrows. When it no longer moves, in this direction, stop tightening* immediately.
	[* 6] Check whether the bearings can slide along the slot.
	[* 6] If the bearing can slide: tighten *evenly, incrementally and in turn, the M3x25 screws until you can't move it anymore. Do not over-tighten!*
	[* 6] If the bearing is not moving anymore: continue to the next bearing.
	[* 1] Repeat this step for the two remaining bearings.

	[title] Y bearings installation - MK3(S)
	[* 9] Take your time with this step. It is important that it is done correctly or it can cause issues later with your printer. *Do not over-tighten the bearings* or you may cause permanent damage to them.
	[* 3] Secure the bearing holders with 6x M3x25 screws. Do *NOT* tighten them yet!
-	[* 5] Start tightening, *evenly, incrementally and in turn. the M3x25 screws. While tightening, test if the bearing can rotate in the directions shown by the red arrows. When it no longer moves, in this direction, stop tightening* immediately.
+	[* 5] Start tightening, *evenly, incrementally and in turn. the M3x25 screws. While tightening, test if the bearing holder can rotate in the directions shown by the red arrows. When it no longer moves, in this direction, stop tightening* immediately.
	[* 6] Check whether the bearings can slide along the slot.
	[* 6] If the bearing can slide: tighten *evenly, incrementally and in turn, the M3x25 screws until you can't move it anymore. Do not over-tighten!*
	[* 6] If the bearing is not moving anymore: continue to the next bearing.
	[* 1] Repeat this step for the two remaining bearings.