Changes to Step #8

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Prepare Y belt holder
-[* 10] Part is a little different depending the version of Prusa you have but this step is the same for all of them.
-[* 1] Do not tighten strongly yet.
-[* 1] Reserve the Y belt holder for later use
+[* 10] This part might look a bit different depending the version of Prusa you are building. However, this step is the same for all of them.
+[* 5] Insert 1x square nut into the ''y_belt_holder''.
+[* 7] Screw an M3x18 from the top. No need to tighten it strongly for now.
+[* 1] Reserve the ''y_belt_holder'' for later use.