Changes to Step #8

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Prepare Y belt holder
-[* 10] This part might look a bit different depending the version of Prusa you are building. However, this step is the same for all of them.
-[* 5] Insert 1x square nut into the ''y_belt_holder''.
-[* 7] Screw an M3x18 from the top. No need to tighten it strongly for now.
-[* 1] Reserve the ''y_belt_holder'' for later use.
+[* 10] The part you use in this step, might look different to that shown in the instructions, depending on which Prusa variant thatyou are building. However, the following instructions are the same for each variant.
+[* 5] Insert 1x square nut into the ''y_belt_holder'', as shown.
+[* 7] Thread in an M3x18 screw, from the top. Do not tighten it yet.
+[* 1] Keep the ''y_belt_holder'' for later use.