Changes to Step #8

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Prepare Y belt holder
-[* 10] The part you use in this step, might look different to that shown in the instructions, depending on which Prusa variant thatyou are building. However, the following instructions are the same for each variant.
+[* 10] The part you use in this step, might look different to that shown in the instructions, depending on which Prusa variant you are building. However, the following instructions are the same for each variant.
[* 5] Insert 1x square nut into the ''y_belt_holder'', as shown.
[* 7] Thread in an M3x18 screw, from the top. Do not tighten it yet.
[* 1] Keep the ''y_belt_holder'' for later use.