Changes to Step #16
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 9] Take your time with this step it is an important one that can cause issues later with your printer. |
|---|---|
| + | [* 9] Be careful, if you tighten too much the bearings you will damage them. |
| + | [* 5] Start tightening ***equally*** the M3x25 screws. While tightening, test if the bearing can rotate on itself (red arrows). When it ***stop rotating***, ***stop*** tightening immediately. |
| + | [* 6] Verify if the bearings can slide along the slot. |
| + | [* 6] If the bearing can slide: tighten ***equally*** the M3x25 screws until you can't move it anymore. ***Do not overtighten!*** |
| + | [* 6] If the bearing is not moving anymore: continue to the next bearing. |
| + | [* 1] Repeat this step for the two remaining bearings. |
Image 1
No previous image
Added
Image 2
No previous image
Added