Changes to Step #16

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[* 9] Take your time with this step it is an important one that can cause issues later with your printer.
-[* 9] Be careful, if you tighten too much the bearings you will damage them.
-[* 5] Start tightening ***equally*** the M3x25 screws. While tightening, test if the bearing can rotate on itself (red arrows). When it ***stop rotating***, ***stop*** tightening immediately.
+[* 9] Take your time with this step it is an important one that can cause issues later with your printer. ***Do not over-tighten the bearings*** or you might damage them permanently.
+[* 5] Start tightening ***equally*** the M3x25 screws. While tightening, test if the bearing can rotate on itself (red arrows). When it ***stop rotating***, ***stop tightening*** immediately.
[* 6] Verify if the bearings can slide along the slot.
- [* 6] If the bearing can slide: tighten ***equally*** the M3x25 screws until you can't move it anymore. ***Do not overtighten!***
+ [* 6] If the bearing can slide: tighten ***equally*** the M3x25 screws until you can't move it anymore. ***Do not over-tighten!***
[* 6] If the bearing is not moving anymore: continue to the next bearing.
[* 1] Repeat this step for the two remaining bearings.