Changes to Step #16
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] Y bearings installation |
|---|---|
| + | [title] Y bearings installation - MK2(S)/MK2.5(S) |
| [* 9] Take your time with this step it is an important one that can cause issues later with your printer. ***Do not over-tighten the bearings*** or you might damage them permanently. | |
| [* 5] Start tightening ***equally*** the M3x25 screws. While tightening, test if the bearing can rotate on itself (red arrows). When it ***stop rotating***, ***stop tightening*** immediately. | |
| [* 6] Check if the bearings can slide along the slot. | |
| [* 6] If the bearing can slide: tighten ***equally*** the M3x25 screws until you can't move it anymore. ***Do not over-tighten!*** | |
| [* 6] If the bearing is not moving anymore: continue to the next bearing. | |
| [* 1] Repeat this step for the two remaining bearings. |