Changes to Step #21

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 7] Remove M3x25 screw previously installed from the ''y_idler_mount'' and ***add a washer*** on the screw.
[* 5] Place the ''y_idler_tensioner'' and screw back the M3x25 with its washer.
[* 2] Insert an M3 locknut to the left side of the ''y_idler_mount'' and screw an M3x30 from the other side. Use the screw to help the locknut going in its cavity. Do not tighten this screw too much, the ''y_idler_tensioner'' should move with almost no resistance.
[* 9] Verify you have a washer on the top M3 screw.
-[* 9] Verify the y_idler_tensioner can move with almost no resistance.
+[* 9] Verify the ''y_idler_tensioner'' can move with almost no resistance.