Changes to Step #21
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] Y idler tensioner installation |
|---|---|
| + | [title] Y idler tensioner installation - MK2(S)/MK2.5(S) |
| [* 7] Remove M3x25 screw previously installed from the ''y_idler_mount'' and ***add a washer*** on the screw. | |
| [* 5] Place the ''y_idler_tensioner'' and screw back the M3x25 with its washer. | |
| [* 2] Insert an M3 locknut to the left side of the ''y_idler_mount'' and screw an M3x30 from the other side. Use the screw to help the locknut going in its cavity. Do not tighten this screw too much, the ''y_idler_tensioner'' should move with almost no resistance. | |
| [* 9] Verify you have a washer on the top M3 screw. | |
| [* 9] Verify the ''y_idler_tensioner'' can move with almost no resistance. |