Changes to Step #21

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y idler tensioner installation - MK2(S)/MK2.5(S)
[* 7] Remove the M3x25 screw, used during installation, from the ''y_idler_mount'' and ***add a washer*** to the screw.
[* 5] Insert the ''y_idler_tensioner'' into the ''y_idler_mount'' and reinsert the M3x25 screw with its washer.
[* 2] Insert an M3 locknut into the left side of the ''y_idler_mount'' and thread an M3x30 screw from the other side. Use this screw to help seat locknut correctly, in the part. Do not over-tighten this screw, the ''y_idler_tensioner'' should move with almost no resistance.
[* 9] Confirm you have a washer on the M3x25 tensioning screw.
-[* 9] check that the ''y_idler_tensioner'' can move with almost no resistance.
+[* 9] Check that the ''y_idler_tensioner'' can move with almost no resistance.