Changes to Step #35

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y idler tensioner installation - MK3(S)
-[* 7] Remove M3x25 screw previously installed from the ''y_idler_mount'' and ***add a washer*** on the screw.
-[* 5] Place the ''y_idler_tensioner'' and screw back the M3x25 with its washer.
-[* 2] Insert an M3 locknut to the left side of the ''y_idler_mount'' and screw an M3x30 from the other side. Use the screw to help the locknut going in its cavity. Do not tighten this screw too much, the ''y_idler_tensioner'' should move with almost no resistance.
-[* 9] Verify you have a washer on the top M3 screw.
-[* 9] Verify the ''y_idler_tensioner'' can move with almost no resistance.
+[* 7] Remove the M3x25 screw, used during installation, from the ''y_idler_mount'' and ***add a washer*** to the screw.
+[* 5] Insert the ''y_idler_tensioner'' into the ''y_idler_mount'' and reinsert the M3x25 screw with its washer.
+[* 2] Insert an M3 locknut into the left side of the ''y_idler_mount'' and thread an M3x30 screw from the other side. Use this screw to help seat locknut correctly, in the part. Do not over-tighten this screw, the ''y_idler_tensioner'' should move with almost no resistance.
+[* 9] Confirm you have a washer on the M3x25 tensioning screw.
+[* 9] Check that the ''y_idler_tensioner'' can move with almost no resistance.