Changes to Step #23
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 7] Insert the belt in the left side of the ''y_belt_holder''. Use a slotted screwdriver to help pushing the belt fully inside. |
|---|---|
| + | [* 5] Continue to route the belt around the Y motor's pulley and finish by inserting the belt into the ''y_belt_holder''. The belt should have almost no tension, it will be adjusted later. |
| + | [* 10] If the belt is too long to fit inside the ''y_belt_holder'' you can trim the excess. |
| + | [* 9] Verify that the belt is fully inserted into the slot. |
| + | [* 4] Tighten the M3x18 screw to secure the belt. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added