Changes to Step #23
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] Y belt installation |
|---|---|
| + | [title] Y belt installation - MK2(S)/MK2.5(S) |
| [* 7] Insert the top section of the belt in the left side of the ''y_belt_holder''. Use a slotted screwdriver to help pushing the belt fully inside. | |
| [* 9] Make sure the belt teeth are correctly oriented according to the shape of the ''y_belt_holder''. | |
| [* 5] Continue to route the belt around the Y motor pulley and finish by inserting the belt into the ''y_belt_holder''. The belt should have almost no tension, it will be adjusted later. | |
| [* 10] If the belt is too long to fit inside the ''y_belt_holder'' you can trim the excess. | |
| [* 9] Verify that the belt is fully inserted into the slot. | |
| [* 6] Tighten the M3x18 screw to secure the belt. |