Changes to Step #23

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y belt installation - MK2(S)/MK2.5(S)
-[* 7] Insert the top section of the belt in the left side of the ''y_belt_holder''. Use a slotted screwdriver to help pushing the belt fully inside.
+[* 7] Insert the top section of the belt into the left side of the ''y_belt_holder''. If necessary, use a small slotted screwdriver to help insert the belt. The belt should be inserted to the full depth of the groove .
[* 9] Make sure the belt teeth are correctly oriented according to the shape of the ''y_belt_holder''.
[* 5] Continue to route the belt around the Y motor pulley and finish by inserting the belt into the ''y_belt_holder''. The belt should have almost no tension, it will be adjusted later.
[* 10] If the belt is too long to fit inside the ''y_belt_holder'' you can trim the excess.
[* 9] Verify that the belt is fully inserted into the slot.
[* 6] Tighten the M3x18 screw to secure the belt.