Changes to Step #24

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 7] Apply a light tension on the belt to avoid having it being floppy. Do not over-tighten the belt or the adjustments will be impossible.
[* 10] we will adjust precisely the belt tension in a later step.
[* 5] Adjust the position of ''y_idler_mount'' and ''y_motor_mount'' using their M5 screws. Try to have the belt ridding as centered as possible on the pulley (motor side) and the idler (tensioner side).
[* 2] It is important to move the Y carriage back and forth along the whole axis between each adjustment.
+ [* 9] When you tighten the ''y_idler_mount'' and ''y_motor_mount'' M5 screws you must do it ***incrementally***. If you don't do it you might have the printed part misaligned.