Changes to Step #24
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Y axis positionning |
|---|---|
| [* 7] Apply a light tension on the belt to have a light stretching (not floppy). Do not over-tighten the belt or the adjustments will be impossible. | |
| [* 10] We will adjust precisely the belt tension in a later step. | |
| [* 5] Adjust the position of ''y_idler_mount'' and ''y_motor_mount'' using their M5 screws. Try to have the belt ridding as centered as possible on the pulley (motor side) and the idler (tensioner side). | |
| [* 2] It is important to move the Y carriage back and forth along the whole axis between each adjustments. | |
| [* 9] Remember that when you tighten the ''y_idler_mount'' and ''y_motor_mount'' screws you must do it ***incrementally***. If you don't do it you might have the those parts misaligned. |