Changes to Step #24
Edit by Ian Middleton —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] Y axis parts position |
|---|---|
| + | [title] Y axis parts position refinement - MK2(S)/MK2.5(S) |
| [* 7] Apply a light tension to the belt to remove any slack. Do not over-tighten the belt or adjustments will be impossible. | |
| [* 10] We will adjust the belt, to the correct tension, in a later step. | |
| [* 5] Adjust the position of ''y_idler_mount'' and ''y_motor_mount'' using their M5 screws. Try to have the belt ridding centred as best as possible on the pulley (motor side) and the idler (tensioner side). | |
| [* 2] It is important to move the Y carriage back and forth along the whole axis between each adjustment. | |
| [* 9] Remember that when you tighten the ''y_idler_mount'' and ''y_motor_mount'' screws you must do so ***evenly, incrementally and in turn***. If you don't do this you may cause those parts to be misaligned. |