Changes to Step #1

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Printed parts verification
-[* 1] If you haven't check the Z axis parts during the [guide|42|preflight check|stepid=462] then you should do it now or you might have problem during this chapter.
-[* 10] Note that in this chapter you will see images of MK3(S) Y carriage but all steps are exactly the same for MK2(S) and MK2.5(S).
+[* 1] If you didn't check the Z axis parts during the [guide|42|preflight check|stepid=462] then you should do it now or you may have problems during this chapter.
+[* 10] Note that in this chapter, images will only show the MK3(S) Y carriage, but that all steps are exactly the same for the MK2(S) and MK2.5(S).