Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 6] Make sure this section is clean of dust, it will be used as reference for the ''z_motor_mounts''. |
|---|---|
| + | [* 5] Slide the z_motor_mount from the top of the frame. Note the orientation, the hole for the Z smooth rods should face outside the frame |
| + | [* 9] Check the orientation of your ''z_motor_mount'' or it will make the next steps impossible. |
| + | [* 10] This step and the following ones are showing a MK3(S) Y carriage but the position is the same with MK2(S) and MK2.5(S). |
Image 1
No previous image
Added
Image 2
No previous image
Added