Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] Z motor |
|---|---|
| + | [title] Z motor mounts installation |
| [* 6] Make sure this section is clean of dust, it will be used as reference for the ''z_motor_mounts''. | |
| [* 5] Slide the z_motor_mount from the top of the frame. Note the orientation, the hole for the Z smooth rods should face outside the frame | |
| [* 9] Check the orientation of your ''z_motor_mount'' or it will make the next steps impossible. | |
| [* 10] This step and the following ones are showing a MK3(S) Y carriage but the position is the same with MK2(S) and MK2.5(S). |