Changes to Step #4

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Z motor mounts installation
[* 6] Make sure this section is clean of dust, it will be used as reference for the ''z_motor_mounts''.
-[* 5] Slide the z_motor_mount from the top of the frame. Note the orientation, the hole for the Z smooth rods should face outside the frame
+[* 5] Slide the z_motor_mount from the top of the frame, slotting the t-nuts into the extrusion channels. Note the orientation, the hole for the Z smooth rods should be to the outside the frame
[* 9] Double check the orientation of your ''z_motor_mount'' or it will make the next steps impossible.