Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Z motor mounts installation | |
| [* 6] Make sure this section is clean of dust, it will be used as reference for the ''z_motor_mounts''. | |
| [* 5] Slide the z_motor_mount from the top of the frame, slotting the t-nuts into the extrusion channels. Note the orientation, the hole for the Z smooth rods should be to the outside the frame | |
| + | [* 1] Tighten the M5x10 strongly. |
| [* 9] Double check the orientation of your ''z_motor_mount'' or it will make the next steps impossible. |