Changes to Step #5
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 5] Slide the Z motors in the ''z_motor_mounts''. The motor cable should be oriented inside the frame (red lines on the images). |
|---|---|
| + | [* 6] Secure the Z steppers in place with 8x M3x10 screws (reused from your original Prusa). Press the motor in the direction of the yellow arrows while tightening ***incrementally*** the screws. |
| + | [* 9] Check the orientation of your motor cables. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added