Changes to Step #5

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Z motors installation
-[* 5] Slide the Z motors in the ''z_motor_mounts''. The motor cable should be oriented inside the frame (red lines on the images).
-[* 6] Secure the Z motors in place with 8x M3x***10*** screws (reused from your original Prusa). Press the motor in the direction of the yellow arrows while tightening ***incrementally*** the screws.
- [* 10] Note that the previous ''z_motor_mounts'' of Bear 2.0 was using M3x12 screws and they will be too long for these new mounts.
+[* 5] Slide the Z motors in the ''z_motor_mounts''. The motor cable should be oriented towards the inside of the frame (red lines on the images).
+[* 6] Secure the Z motors in place with 8x M3x***10*** screws (reused from your original Prusa). Press the motor in the direction of the yellow arrows while tightening the screws ***evenly, incrementally and in turn***.
+ [* 10] Note that the previous, Bear 2.0 ''z_motor_mounts',' used M3x12 screws and they will be too long for these new mounts.
[* 9] Check the orientation of your motor cables.