Changes to Step #5
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Z motors installation | |
| [* 5] Slide the Z motors in the ''z_motor_mounts''. The motor cable should be oriented towards the inside of the frame (red lines on the images). | |
| [* 9] The Z motors have different cable length. The motor with shorter cables must go on the side of the dual Y axis bearing (left on the images). | |
| [* 6] Secure the Z motors in place with 8x M3x***10*** screws (reused from your original Prusa). Press the motor in the direction of the yellow arrows while tightening the screws ***evenly, incrementally and in turn***. | |
| [* 10] Note that the previous, Bear 2.0 ''z_motor_mounts',' used M3x12 screws and they will be too long for these new mounts. | |
| + | [* 10] Previous version of Bear or Original Prusa are using washer on the M3x10. This is not useful anymore, you can discard them. |
| [* 9] Check the orientation of your motor cables. |