Changes to Step #2

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[* 2] Make sure you have remove the original lead screw covers as specified in the [guide|42|preflight check and disassembly|stepid=470] guide
+[* 2] Make sure you have removed the original lead screw covers as specified in the [guide|42|preflight check and disassembly|stepid=470] guide
[* 10] This is not optional, the original ones are not compatible with the Bear Z motor mounts.
[* 5] Screw the Bear ''z_leadscrew_cap'' on both steppers.
[* 9] The ''z_leadscrew_caps'' should screw down to the Z motor but should not be tight at all. Make sure the lead screw can turn freely.